Superdeals

Imitates morning mist in desert terrariums and simulates tropical mist in tropical terrariums.

Increases air humidity up 100% depending on the size of the terárium.

With automatic low water protection: if the water is low (< 3cm), the device will automatically shut down.

Suitable not only for terrariums, but also for other water containers.

Great visual effect.

REPTI PLANET replacement membranes can be purchased separately.

Caution: Always make sure there is sufficiently high water level in the tank.

Ultrasonic fog generation - Instruction Instruction to use:

This product generates a cold mist with help of ultrasonic ceramic disk (membrane) at normal temperature, which can increase the moisture in the terrarium (room) and produces negative ions for air freshening. The product can also be used as a decoration - for example, a miniature fountain with an interesting misty effect.

Operation specifiations:

1. Place the Fogger into a water container and keep flat ( optimal water level is 20mm to 40mm above the ceramic disk).

2. Connect the power cable of the Fogger to the transformer. Plug the cable from the transformer into an electrical outlet. The fogger begins to generate a water mist. At the same time, the LED will light up.

Notes:

1. Don´t manipulate with the Fogger when connected to the power supply, this may damage the device.

2. Don´t run the Fogger for more than 10 hours per day.

3. Don´t touch the ceramic disk (membrane) while the Fogger is in use.

4. Use clean water, dirty water will reduce the time of operation the Fogger.

5. Please disconnected the power supply before moving or maintenance.

6. The ceramic disk (membrane) is consumer goods, the life time is approximately 3000 hours. If you find a reduction in the amount of fog produced, clean the ceramic membrane with a cotton pad (do not use any detergent). If there is even less fog after cleaning, replace the used membrane with a new one.

7. When replacing the ceramic disk (membrane), please refer to the instruction. Pay attention to keep the inside area of the device completely dry and make sure to install ceramic disk (membrane) with correct side (side without black loop) facing up.

Parameters of the Fogger

Input voltage: A/C 24V Input electric current: 400mA Power: 12W

Working temperature: +5°C - +45°C Water rate: >250ml/h

The best depth of the water: 2,5 – 3,5cm above the ceramic
Imitates morning mist in desert terrariums and simulates tropical mist in tropical terrariums. Increases air humidity up 100% depending on the size of the terárium. With automatic low water protection: if the water is low (< 3cm), the device will automatically shut down. Suitable not only for terrariums, but also for other water containers. Great visual effect. REPTI PLANET replacement membranes can be purchased separately. Caution: Always make sure there is sufficiently high water level in the tank. Ultrasonic fog generation - Instruction Instruction to use: This product generates a cold mist with help of ultrasonic ceramic disk (membrane) at normal temperature, which can increase the moisture in the terrarium (room) and produces negative ions for air freshening. The product can also be used as a decoration - for example, a miniature fountain with an interesting misty effect. Operation specifiations: 1. Place the Fogger into a water container and keep flat ( optimal water level is 20mm to 40mm above the ceramic disk). 2. Connect the power cable of the Fogger to the transformer. Plug the cable from the transformer into an electrical outlet. The fogger begins to generate a water mist. At the same time, the LED will light up. Notes: 1. Don´t manipulate with the Fogger when connected to the power supply, this may damage the device. 2. Don´t run the Fogger for more than 10 hours per day. 3. Don´t touch the ceramic disk (membrane) while the Fogger is in use. 4. Use clean water, dirty water will reduce the time of operation the Fogger. 5. Please disconnected the power supply before moving or maintenance. 6. The ceramic disk (membrane) is consumer goods, the life time is approximately 3000 hours. If you find a reduction in the amount of fog produced, clean the ceramic membrane with a cotton pad (do not use any detergent). If there is even less fog after cleaning, replace the used membrane with a new one. 7. When replacing the ceramic disk (membrane), please refer to the instruction. Pay attention to keep the inside area of the device completely dry and make sure to install ceramic disk (membrane) with correct side (side without black loop) facing up. Parameters of the Fogger Input voltage: A/C 24V Input electric current: 400mA Power: 12W Working temperature: +5°C - +45°C Water rate: >250ml/h The best depth of the water: 2,5 – 3,5cm above the ceramic
Double ceramic lamp holder for terrariums with reflector
Suitable for spot lights up to 40W (per lamp base)
The aluminum reflector promotes heat and light concentration in the terrarium
Compact size
Increases the intensity of UVB radiation
Includes two independent on/off switches
E27 bulb fitting
The ventilation openings at the top of the lamp provide sufficient ventilation
Hanging hook included

Ideal for use with REPTI PLANET Small terrariums. The highly polished aluminum reflector increases light intensity, UVB and UVA output. The small dimensions of the lamp allow installation directly on to the terrarium top screen mesh cover or it is possible to use the original lamp holder (not included). The lamp can be used separately for the heat and UVB bulb or for night and daylight bulbs.

Safety instructions:
1.COMBO DOME Lamp Fixture is non-waterproof, should not be used in water or any damp environment. 2. It is forbidden to inconsiderately manipulate the power cord, to prevent damage. 3. Unplug the device if not in use for a long period. 4. Check power cord before use. If the cable is damaged, switch off the light immediately. 5. Unplug immediately if you find that the device is smoking or emitting non-standard light. 6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person responsibe for their safety. Children should be supervised to ensure that they do not play with appliance.
Double ceramic lamp holder for terrariums with reflector Suitable for spot lights up to 40W (per lamp base) The aluminum reflector promotes heat and light concentration in the terrarium Compact size Increases the intensity of UVB radiation Includes two independent on/off switches E27 bulb fitting The ventilation openings at the top of the lamp provide sufficient ventilation Hanging hook included Ideal for use with REPTI PLANET Small terrariums. The highly polished aluminum reflector increases light intensity, UVB and UVA output. The small dimensions of the lamp allow installation directly on to the terrarium top screen mesh cover or it is possible to use the original lamp holder (not included). The lamp can be used separately for the heat and UVB bulb or for night and daylight bulbs. Safety instructions: 1.COMBO DOME Lamp Fixture is non-waterproof, should not be used in water or any damp environment. 2. It is forbidden to inconsiderately manipulate the power cord, to prevent damage. 3. Unplug the device if not in use for a long period. 4. Check power cord before use. If the cable is damaged, switch off the light immediately. 5. Unplug immediately if you find that the device is smoking or emitting non-standard light. 6. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person responsibe for their safety. Children should be supervised to ensure that they do not play with appliance.
Brushed aluminum
6500K natural white color LED output
465nm blue color LED output
20 000 hours lifetime for LED
Touch switch
Adjustable intensity of LED light
Attractive appearance
Minimum height
Memory function

LED Light Lamp – Instructions
This product is designed as a popular and energy saving aluminium light lamp for animals and plants. It consists of 24 pcs 6500k white natural LED lights and 6 pcs 465nm blue LED lights. This lamp is suitable for REPTI PLANET terrariums, acrylic breeding tanks and other terrarium and aquariums.

Please read these instructions prior to use of your new LED light lamp
1. Aluminum main body
2. Control box with touch switch
3. Adaptor

Part list
Aluminum main body and control box, 1pc
User manual, 1 pc
Adaptor, 1pc

Specification
– Brushed aluminum
– 6500K natural white color LED output
– 465nm blue color LED output
– 20 000h lifetime for LED
– Touch switch
– Adjustable intensity of LED light
– Attractive appearance
– Minimum hight
– Memory function

Technical data
Power: 6W
LED light lifetime: 20 000h
Product size: 132x90x9,5mm
Control box size: 65x45x23mm
Package size: 145x98x70mm
Input: 110-240V 50/60HZ
Output: 12DCV
Output current: Max 0,5A
>0,8 Power cord >1,6m Control box Output cord

Installation and usage

Adaptor
Connect the control box with touch switch with AC adaptor (Input 110-240V, Output 12DCV)

Main body and control box
REPTI PLANET LED light lamp can be put directly on the top of the mesh cover of terrariums or put on the aquariums with extra holder (not included)

Power on/off and operating mode switch
The control box provides three operating modes (white color, blue color, both white and blue color).
To switch between modes, touch the touch-screen switch only.

O – Stand by mode
1 – White color LED light mode
2 – Blue color LED light mode
3 – Both white and blue color LED light mode

Simple adjustment for light
The light setting is available in the following modes: white, blue, white and blue. First select the operating mode. To adjust the intensity of the desired light, press the control panel (will lighten or darken).

Safety instructions

1. LED light lamp is non-waterproof, should not be used in water or any damp environment
2. Use the original adaptor only to avoid of damaging LED lights
3. It is forbidden to inconsiderately manipulate with the power cord, preventing damage
4. Unplug the device if not in use for a long period
5. Check power cord before use. If the cable is damaged, switch off the light immediately
6. Unplug immediately if you find that the device is smoking or emitting non-standard light
7. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person responsibe for their safety. Children should be supervised to ensure thay they do not play with appliance
Brushed aluminum 6500K natural white color LED output 465nm blue color LED output 20 000 hours lifetime for LED Touch switch Adjustable intensity of LED light Attractive appearance Minimum height Memory function LED Light Lamp – Instructions This product is designed as a popular and energy saving aluminium light lamp for animals and plants. It consists of 24 pcs 6500k white natural LED lights and 6 pcs 465nm blue LED lights. This lamp is suitable for REPTI PLANET terrariums, acrylic breeding tanks and other terrarium and aquariums. Please read these instructions prior to use of your new LED light lamp 1. Aluminum main body 2. Control box with touch switch 3. Adaptor Part list Aluminum main body and control box, 1pc User manual, 1 pc Adaptor, 1pc Specification – Brushed aluminum – 6500K natural white color LED output – 465nm blue color LED output – 20 000h lifetime for LED – Touch switch – Adjustable intensity of LED light – Attractive appearance – Minimum hight – Memory function Technical data Power: 6W LED light lifetime: 20 000h Product size: 132x90x9,5mm Control box size: 65x45x23mm Package size: 145x98x70mm Input: 110-240V 50/60HZ Output: 12DCV Output current: Max 0,5A >0,8 Power cord >1,6m Control box Output cord Installation and usage Adaptor Connect the control box with touch switch with AC adaptor (Input 110-240V, Output 12DCV) Main body and control box REPTI PLANET LED light lamp can be put directly on the top of the mesh cover of terrariums or put on the aquariums with extra holder (not included) Power on/off and operating mode switch The control box provides three operating modes (white color, blue color, both white and blue color). To switch between modes, touch the touch-screen switch only. O – Stand by mode 1 – White color LED light mode 2 – Blue color LED light mode 3 – Both white and blue color LED light mode Simple adjustment for light The light setting is available in the following modes: white, blue, white and blue. First select the operating mode. To adjust the intensity of the desired light, press the control panel (will lighten or darken). Safety instructions 1. LED light lamp is non-waterproof, should not be used in water or any damp environment 2. Use the original adaptor only to avoid of damaging LED lights 3. It is forbidden to inconsiderately manipulate with the power cord, preventing damage 4. Unplug the device if not in use for a long period 5. Check power cord before use. If the cable is damaged, switch off the light immediately 6. Unplug immediately if you find that the device is smoking or emitting non-standard light 7. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of appliance by a person responsibe for their safety. Children should be supervised to ensure thay they do not play with appliance
Sorting